09/13 Rev. G 143593
The cap catcher is also shipped inside the cabinet. The cap catcher is to be installed on
the left front of the cabinet using the two mounting screws on the cabinet and the two
keyhole slots on the back of the cap catcher. Loosen the screws and slide the cap
catcher over them. Leave the screws loose so the cap catcher can be removed for
emptying.
OPERATION AND MAINTENANCE
This cooler is designed to maintain your product temperature within the most desirable
range of +34°F to +38°F. You can expect this temperature with the proper temperature
control setting and in a normal environment. It is important to remember that when the
product is delivered, it must be placed inside the cooler as soon as possible to avoid
excessive warm up. If this happens, it may take many hours for the temperature to be
reduced to the desirable range.
The temperature controller is located on the inside back wall of the unit. Turn the
control clockwise for cooler temperatures and counterclockwise for warmer
temperatures. Allow the unit several hours to respond to temperature control
adjustments.
When loading the cabinet with product, do not block the air flow path at the back.
Blocking the air flow may decrease performance. Maintain clearance between the
contents and air duct for best performance.
This equipment is intended for the storage and display of non-potentially hazardous
bottled or canned products only.
Cleaning
Beginning with the initial installation, the interior surfaces of the cabinet should be
periodically cleaned with a solution of warm water and baking soda. This solution will
remove any odors from spillage that has occurred. The exterior of the cabinet should
also be cleaned frequently with a commercial stainless steel cleaner, glass cleaner or
mild soap solution. Do not use chlorinated cleaners on any surfaces.
The product dividers can be cleaned in a sink with a mild soap solution and a soft
bristled brush.
Periodically the unit should be emptied and cleaned out. There is a drain in the floor of
the cabinet that drains to a drain hose on the back of the cabinet in the compressor
compartment. Be sure to use this drain line for cleaning out the cabinet interior.
Condenser Coil
Prior to cleaning the condenser coil disconnect the unit from power. Periodic cleaning
of the condenser coil will aid the heat transfer of the refrigeration system and increase
its efficiency. To accomplish this, remove the lower front grill from the cabinet. The
condenser coil is located behind the grill. Use a soft bristled brush to remove any dirt
particles that are on the fins of the condenser coil. Use a vacuum cleaner or
compressed air to remove the loosened particles.
