Figure 3-17: Rubber Gasket and Cable
Step 5: Repeat steps to other connected cables.
Step 6: Install the I/O cover and make sure each rubber gasket snaps into place tightly.
Step 7: Secure the I/O cover by the previously removed retention screws.
Figure 3-18: External Peripheral Device Connection Complete
3.7.2 ACC Mode Selection
The ACC mode can be turned on or off. The setting is made through the ACC mode switch
on the bottom panel as shown below.
Figure 3-19: ACC Mode Switch
3.7.3 AT/ATX Power Mode Selection
The UPC-V315-QM77 supports both AT and ATX power modes. The setting can be made
through the AT/ATX power mode switch on the bottom panel as shown below.
