Produtos da Marca Dell

Back to Contents Page

Setup Instructions

Hardware Installation

Driver Installation

Hardware Installation

VerifythattheDellXcelerator™isinstalled.

1. Follow instructions in the manual for removing the cover from the chassis.

2. TheDellXcelerator™hardwareisinstalledinadrivebayinsidethechassis(seepicturebelow).

3. Verify that the board is installed.

ConnectingtheDellXcelerator™device

1. VerifythatthereisacablethatconnectstheDellXcelerator™boardtothemotherboard.

2. Verify that this cable is firmly installed into each connector.

3. Reinstall the cover back onto the chassis.

Driver Installation

If the driver and the hardware are not installed or if you need to reinstall them, perform the following steps:

1. With Windows®running on your computer, insert the Dell Resource CD into your CD/DVD drive.

2. If the Dell Resource CD window does not open automatically, double click on My Computer on your desktop and then double click on the CD/DVD drive

containing the Dell Resource CD.

3. Follow the instructions provided by the Dell ResourceCDtolocatethedriverpackageforyourDellXcelerator™card.

4. Once you have located the package, select the Lumanate setup.exe to unzip the drivers on to the hard drive and install the drivers.

5. At the Setup Complete screen, select Yes and click Finish to restart your system.

Back to Contents Page

CAUTION: Shut down your computer and unplug the power cord to prevent any personal or equipment damage.

NOTE:TheDellXcelerator™hardwarecomespre-installed into the system. The following steps should only be done if a problem occurs with the

device.