Produtos da Marca Dell

Back to Contents Page

 Front USB 3.0 Assembly

Dell™StudioXPS™9100ServiceManual

Removing the Front USB 3.0 Assembly

Replacing the Front USB 3.0 Assembly



Removing the Front USB 3.0 Assembly



1. Follow the instructions in Before You Begin.



2. Remove the computer cover (see Removing the Computer Cover).



3. Remove the front bezel (see Removing the Front Bezel).



4. Disconnect the USB 3.0 cable from the connector on the expansion card.



5. Remove the two screws that secure the front USB 3.0 assembly to the chassis.



6. Push and slide the front USB 3.0 assembly out through the front of the computer.



7. Set the front USB 3.0 assembly aside in a secure location.

Replacing the Front USB 3.0 Assembly



1. Follow the instructions in Before You Begin.



2. Gently slide the front USB 3.0 assembly into the FlexBay slot through the front of the computer.



3. Replace the two screws that secure the front USB 3.0 assembly to the chassis.



WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)

removed.

CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™

is not covered by your warranty.

USB 3.0 cable

front USB 3.0 assembly

screws (2)