Produtos da Marca Dell

Bad error-correctioncode(ECC)ondiskread— See "Drive Problems."

Controllerhasfailed— See "Drive Problems."

Dataerror— See "Drive Problems."

Decreasingavailablememory—

See "Lockups and Software Problems."

Diskettedrive0seekfailure— See "Drive Problems."

Diskettereadfailure—

See "Drive Problems."

Diskettesubsystemresetfailed— Run the Dell Diagnostics.

Diskettewriteprotected— Slide the write-protect notch to the open position.

Drivenotready— Put a floppy disk in the drive.

GateA20failure—

See "Lockups and Software Problems."

Hard-diskconfigurationerror—

Hard-diskcontrollerfailure—

Hard-diskdrivefailure—

Hard-diskdrivefailure—

See "Drive Problems."

Insertbootablemedia— Insert a bootable floppy disk or CD.

Invalid configuration information -pleaserunSETUPprogram— Enter system setup and correct the computer configuration information.

Keyboardfailure— See "Keyboard Problems."

Memory address line failure at address, read value expecting value — See "Lockups and Software Problems."

Memoryallocationerror—

1. Turn off the computer, wait 30 seconds, and then restart the computer.

2. Try to run the program again.

3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.

Memory data line failure at address, read value expecting value — 

Memory double word logic failure at address, read value expecting value —

Memory odd/even logic failure at address, read value expecting value —

Memory write/read failure at address, read value expecting value —

MemorysizeinCMOSinvalid— 

See "Lockups and Software Problems."

Nobootdeviceavailable— 

l If the floppy drive is your boot device, ensure that a bootable floppy disk is in the drive.

l If the hard drive is your boot device, ensure that the cables are connected and that the drive is installed properly and partitioned as a

boot device.

l Enter system setup and ensure that the boot sequence information is correct.

No boot sector on hard-diskdrive— Enter system setup and ensure that the computer configuration information for the hard drive is

correct.

Notimertickinterrupt— Run the Dell Diagnostics.

Non-systemdiskordiskerror— Replace the floppy disk with one that has a bootable operating system or remove the floppy disk from

the module bay and restart the computer.

Notabootdiskette— Insert a bootable floppy disk and restart your computer.

Notenoughmemoryorresources.Closesomeprogramsandtryagain— Close all windows and open the program that you want to use.

In some cases, you might have to restart your computer to restore computer resources. If so, run the program that you want to use first.

Operatingsystemnotfound— Contact Dell.

Readfault— 

Requestedsectornotfound— 

Resetfailed—

See "Drive Problems."

Sectornotfound— 

l Run the Windows error-checking utility to check the file structure on the floppy disk or hard drive. See Windows Help for instructions.

l If a large number of sectors are defective, back up the data (if possible), and then reformat the floppy disk or hard drive.

Seekerror— See "Drive Problems."

Shutdownfailure— Run the Dell Diagnostics.

Time-of-dayclockstopped— 

Time-of-day not set-pleaseruntheSystemSetupprogram— Enter system setup and correct the date or time. If the problem persists,

replace the battery.

Timerchipcounter2failed— Run the Dell Diagnostics.

Unexpectedinterruptinprotectedmode— Run the Dell Diagnostics.

WARNING: Dell's Disk Monitoring System has detected that drive [0/1] on the [primary/secondary] EIDE controller is operating