System Setup Program A-5
Serial Port Configures system’s built-in serial port.
Parallel Port Configures system’s built-in parallel port. The
port’s I/O address may be set to 278h
,
3BCh,
or 378h
.
Otherwise, the port may be dis-
abled.
Parallel Mode Controls whether system’s built-in parallel port
acts as an AT-compatible (unidirectional) or
PS/2-compatible (bidirectional) port.
Hard Disk Enables system’s built-in EIDE hard-disk drive
interface.
Diskette Enables system’s built-in diskette drive con-
troller.
USB Enables (On) or disables (Off) the USB con-
nectors.
Speaker Enables on-board speaker.
ECC Enables (On) or disables (Off) the error correc-
tion capability of the memory controller.
NOTE: This field is displayed only when 72-bit
EDO (ECC) DIMMs are installed.
Microprocessor Displays type of microprocessor installed.
External Cache Displays size of external cache memory card
installed.
Video Memory Displays amount of video memory on the sys-
tem board.
System Memory Displays entire amount of installed memory
detected in system, except for memory on EMS
expansion cards.
If EDO DIMMs are installed, EDO is dis-
played next to this category.
Service Tag Displays system’s five-character service tag
number.
Asset Tag Displays the asset tag number up to ten charac-
ters if one is assigned.
Table A-1. System Setup Categories
(continued)
Category Function
