Produtos da Marca Dell

Back to Contents Page

 Speakers

Dell™Inspiron™One19ServiceManual

Removing the Speakers

Replacing the Speakers



Removing the Speakers



1. Follow the procedures in Before You Begin.



2. Remove the I/O cover (see Removing the I/O Cover).



3. Remove the computer stand (see Removing the Computer Stand).



4. Remove the optical drive (see Removing the Optical Drive).



5. Remove the decorative cover (see Removing the Decorative Cover).



6. Remove the speaker cover (see Removing the Speaker Cover).



7. Remove the display bezel (see Removing the Display Bezel).



8. Remove the back cover (see Removing the Back Cover).



9. Remove the I/O bracket (see Removing the I/O Bracket).



10. Remove the inverter (see Removing the Inverter).



11. Remove the system-board shield (see Removing the System-Board Shield).



12. Disconnect the speaker cable from the connector (SPKR1) on the system board. For more information on the location of the speakers connector, see

System Board Components.



13. Remove the four screws (two on each speaker) that secure the speakers to the chassis.



14. Lift the speakers off the chassis.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™

is not covered by your warranty.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

NOTE: Make a note of the cable routing before you dislodge the cable.

speaker-cable connector

speakers (2)