Produtos da Marca Dell

Adding or Removing Cards

1. Shut down the computer.

2. Turn off any attached devices and disconnect them from their electrical outlets.

3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.

4. Remove the computer stand, if it is attached.

5. Open the computer cover.

6. Remove the card cage.

a. Check any cables connected to cards through the back-panel openings. Disconnect any cables that will not reach the card cage once it is

removed from the computer.

b. Gently pull on the handle and lift the card cage up and away from the computer.



7. Press the lever on the retention arm and raise the retention arm.



CAUTION: Before you begin any of the procedures in this section, follow the "Safety Instructions."

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.