Use the J 42069-20 to inspect the alignment of the camshaft gears 3 and 4.21.
Use the J 42069-20 to inspect the alignment of the camshaft gears 1 and 2.22.
If timing belt adjustment IS REQUIRED, refer to Timing Belt Timing Adjustment, See: Service and Repair\Overhaul
\Repair Instructions\92. Timing Belt Timing Adjustment
23.
If timing belt adjustment IS NOT REQUIRED, set the final timing belt tension:24.
24.1 Loosen the timing belt eccentric locking nut.
24.2 Turn the eccentric counter clockwise to full stop, then back to the following specification:
NEW BELT
until the reference mark is 3-4 mm (0.118-0.157 in) (a) above the datum line.
USED BELT
until the reference mark is aligned with the datum line.
Tighten the timing belt tensioner eccentric locking nut to 20 Nm (15 lb ft).
12 of 16
