Produtos da Marca Belkin

Manually Configuring your Modem-Router

section

unless you need to change it. After any changes are made you must

click on “Save Settings” to apply them.

Note: If you check “Enabled” and specify an IP address of 0.0.0.0, any

host can manage the Modem-Router.

For remote management via WAN IP address you need to connect

using port 8080. Simply enter WAN IP address followed by :8080 in the

address field of your web browser, for example, 123.123.123.123:8080.

This applies unless you change the port setting, in which case you

need to substitute the 8080 for whatever port you assign.

DNS

Domain Name Servers

are used to map a

domain name (e.g.,

www.somesite.com) to

the equivalent numerical

IP address (e.g.,

64.147.25.20). Your ISP

should provide the IP

address of one or more

Domain Name Servers.

If your ISP requires you

to manually specify the

addresses, enter them

on this page.

WAN

Specify the WAN (Wide Area Network) connection parameters provided

by your Internet Service Provider (ISP).

ATM PVC

The Modem-Router uses

ATM (Asynchronous

Transfer Mode) as its

WAN interface. Click on

each ATM VC for WAN

configuration.

See the table below

for a description of the

parameters.

Parameter

Description

Click on the VC to set the values for the

connection.

VPI/VCI

Virtual Path Identifier (VPI) and Virtual Circuit

Identifier (VCI).

Encapsulation

Specifies how to handle multiple protocols at the

ATM transport layer.

• VC-MUX - Point-to-Point Protocol over ATM Virtual

Circuit Multiplexer (null encapsulation) allows only

one protocol running per virtual circuit with less

overhead.

• LLC - Point-to-Point Protocol over ATM Logical

Link Control (LLC) allows multiple protocols

running over one virtual circuit (using slightly more

overhead).

Protocol

Protocol used for the connection