Proposal Number PSDF #P09-0004
A display panel shall be supplied in the dash area. The panel shall have an audible indicators and a red light
display to indicate that a seat belt has not been fastened.
SEAT BELT WARNING SYSTEM - MONITOR
Mounted in the overhead console in the driver's area the indicator system shall indicate seat belt use for each
individual seating position when the seat is occupied, the seat belt remains unfastened and the parking brake
is released.
EMS STORAGE CABINET
A storage compartment, full height x 40" W x 20" D shall be provided on the rear wall with the door opening
facing the front of the cab.
The cabinet shall be bolted construction made of 304 stainless steel and with a brushed finish.
The EMS Cabinet shall be installed on centered on the rear wall.
The EMS cabinet shall be provided with a Gortite, or equal, roll up door facing forward. The roll up door
shall be constructed of double sided aluminum extrusions connected with a ball and socket joint. The
extrusions shall be 1-3/8" wide x 3/8" thick with satin anodized finishing. A flexible EDPM extrusion shall
be provided between each slat to insure a weather tight seal. Aluminum extrusions shall be individually
replaceable without disassembling the entire door by removing push out clips on each end.
A vertically hinged door shall be furnished on each end so medical bag, etc could be removed without
climbing into the cab.
Side channels for each door to ride in shall be provided with santoprene seals to prevent dirt and moisture
from entering the exterior compartment. A single piece top drip rail shall be provided with a santoprene seal
to prevent dirt and moisture from entering the compartment when the door is fully closed. The bottom of
each door shall also be provided with a santoprene seal. All nonmetallic parts shall be glass filled nylon.
The door latches shall be keyed locking stainless steel lift bars and shall be provided with a magnetic door
switch system. One key to fit all doors.
EMS CABNIET LIGHTING
Two (2) LED strip lights shall be provided mounted inside the cabinet, one (1) on each side of the roll up
door. These lights shall be controlled by the door switch for illumination.
ALUMINUM SHELVES - ADJUSTABLE - EMS CABINET
Three (3) adjustable aluminum shelves shall be installed and shall have a flange 1-1/2" deep and a minimum
material thickness of .190" up to 30" in length. Each shelf shall be fully adjustable in height and held in
place by extruded uprights.
