4
ECN 15542 . 12/20/13 @ 9.1 . revC
ECN 15371 . 10/1/13@11.1 . rev A
Printed in U.S.A. 12/2013 F-3945 Rev C
SERVICING THE TFT SERVER
REMOVING THE BASE & BOTTOM COVER
To replace the silicone elbow tting for repair or cleaning:
1. Remove the base assembly. Press down on the slide tab on the back side of the stand
and rotate the server counter clock-wise. Lift the server to separate from the base.
2. Turn the server upside down and pry off the plastic bottom cover. This will reveal the
silicone elbow tting.
3. Remove the wire hose clamps by squeezing in on the wire ears. Slide the clamp from
the soft silicone elbow at the liner drain pipe and the faucet shank and pull off the elbow.
4. Check for leaks and replace with a new part if necessary.
REMOVING THE FAUCET
The faucet will require periodic cleaning and maintenance.
1. Remove the faucet from the body of the server. Take off the faucet by unscrewing the wing nut holding
the faucet body to the shank.
2. Disassemble the faucet. Unscrew the bonnet from the body of the faucet. The handle and the faucet
parts will come off in one piece.
3. Check the silicone seat cup for wear, cracks, or hardening. If okay, then leave the seat cup attached on
the handle/bonnet assembly. Soak then wipe clean. Replace the faucet if damaged.
ASSEMBLY
Assemble the unit by reversing the steps for disassembly. Finger tighten the wing nut onto the faucet. Make sure all
clamps are fastened properly and silicone ttings are in good condition. Before replacing the bottom cover, pour water
into the server and check for leaks around the tting and faucet. If okay, pour out the water and replace the cover and
server base. The server is ready for coffee brewing.
TFT 1.5 Gallon
TFT 1.0 Gallon
Product Warranty Information
The Wilbur Curtis Company certies that its products are free from defects in material and workmanship under normal
use. The following limited warranties and conditions apply:
1 Year from the Original Date of Purchase.
RETURN MERCHANDISE AUTHORIZATION: All claims under this warranty must be submitted to the Wilbur Curtis
Company Technical Support Department prior to performing any repair work or return of this equipment to the fac-
tory. All returned equipment must be repackaged properly in the original carton. No units will be accepted if they are
damaged in transit due to improper packaging. NO UNITS OR PARTS WILL BE ACCEPTED WITHOUT A RETURN
MERCHANDISE AUTHORIZATION (RMA). RMA NUMBER MUST BE MARKED ON THE CARTON OR SHIPPING
LABEL. All in-warranty service calls must be performed by an authorized service agent. Call the Wilbur Curtis Techni-
cal Support Department to nd an agent near you.
WILBUR CURTIS CO., INC.
6913 Acco St., Montebello, CA 90640-5403 USA Phone: 800/421-6150 Fax: 323-837-2410
T
echnical Support Phone: 800/995-0417 (M-F 5:30A
- 4:00P
PST) E-Mail:
[email protected]
