Mondial Designs Limited Brand's Products

INSTALLATION INSTRUCTIONS (continued)

Correct 240 Volt Conguration Correct 120 Volt Conguration

CB132T Multi-Watt

CB103T Multi-Volt

DESIRED WATTAGE:

DO NOT DISCONNECT THE YELLOW CONNECTOR FROM TERMINAL "A"

Factory set at 1300 Watts

1300/975

800/600

500/375

WIRE CONFIGURATION240/208V

No change

Disconnect and cut BLUE connector from terminal

C. Wrap loose wire end with electrical tape. Move

YELLOW connector at terminal B to the C terminal.

Cut wire with BLUE connector at terminal C. Wrap

loose wire end with electrical tape.

PN070350

White Wire

Black Wire

Blue Wire

Red Wire

White Wire

Black Wire

Blue Wire

Red Wire

Heater must be connected to a GFCI protected branch circuit.

Refer to wiring diagrams, and Figure 6 for desired voltage. Before

installing the heater, it is extremely important you verify the

heater is congured for the correct supply voltage. The Multi-Volt

Com-Pak Bathroom Heater is congured for 240 volt operation by

default. For 120 volt installation you must recongure the heater

wiring. Installing the heater without conguring for the correct

voltage will destroy the heater and void your warranty.

How to determine the supply voltage:

If replacing an existing heater, check the labels of the old heater

and replace using same voltage. For new construction, heater

wires must be congured to the same voltage as the supply wires.

If you need assistance, consult a qualied electrician.

Select Proper Heater Voltage

STEP 2

For 240 volt conguration:

The Multi-Volt Com-Pak Bathroom Heater is congured for 240

volt operation by default. Important! The red wire and its terminal

end are not connected in this conguration.

For 120 volt Conguration:

To congure heater for 120 volt, disconnect the blue wire from

terminal D and connect it to terminal A. Then connect the loose

red wire to terminal D.

__________________________

Part Two

__________________________

After you have followed all instructions in Part One you are ready to install the heater assembly.

How do I insert the heater assembly into the wall can?

Install Heater Assembly

STEP 3

Install Grill

STEP 4

Secure grill with the screws provided. Slide thermostat knob onto

right control shaft extending through the grill and the timer knob

onto the left shaft. Turn power on at the main disconnect panel.

Turn heater assembly upside down (element down with motor facing up). Connect the supply wires to the heater wires with wire con-

nectors (not included). (See Figures 7 and 8). Now rotate the heater so the element and the fan are facing up. The element should be

at the top.

Insert the bottom edge of the heater assembly into the half round slots in the bottom lip of the wall can (See Figure 9). [IMPORTANT:

Push wires into bottom of wall can during insertion. Be sure that supply wires are not caught between motor and wall can.] Attach

assembly at top with screw provided.

Figure 5

Figure 7 Multi-Volt

(Model CB103 shown)

Figure 8 Multi-Watt

(Model CB132 shown)

Figure 9

How do I congure the Multi-Volt model CB103? How do I congure the Multi-Watt model CB132?

Determine Supply Voltage

STEP 1

Multi-Watt Element Wiring Conguration

STEP 1

Heater must be connected to a GFCI protected branch circuit.

Use the table in Figure 5 to select the correct wattage required,

and the element terminals to be used.

Figure 6

Note: Warranty is void if any material is sprayed on the element

or blower. Use a paint mask to cover any exposed areas of the

heater if walls are to be textured or painted.

Proceed to STEP 3.

Page 4