Prodotti del Marchio Whirlpool

Start-up and use

Measuring out the detergent

A good wash result also depends on the correct amount

of detergent being used; exceeding the stated amount

does not result in a more effective wash and increases

environmental pollution.

Only use detergent which has been specifically

designed for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam

residue remaining in the machine after the cycle has

ended.

The use of tablets is only recommended for models

which offer the MULTI-FUNCTIONAL TABLETS option.

To achieve the best results from each washing and

drying cycle, powder detergent, rinse aid liquid and

salt should be used.

Compartment A:Washingdetergent

Compartment B: Pre-wash detergent

1. Opencover C bypressing

button D.

2. Pour in thedetergent after

consulting the

Table of wash

cycles:

• Forpowder detergent use

compartments A and B.

•Fordetergentintabletform:

when thecycle requires 1

tablet, place it in compartment A and close the cover; when

itrequires2,placethesecondtabletatthebottomofthe

appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

* Only available in selected models.

Starting the dishwasher

1.Turnthewatertapon.

2.PresstheON/OFFbutton:alltheindicatorlightsonthe

control panel will light up for a few seconds.

3. Open the door and pour in a suitable amount of detergent

(see below).

4. Load the racks

(see Loading the racks)

and shut the door.

5. Selectthe wash cycleby turning the WASHCYCLE

SELECT knob in a clockwise direction: align the notch on the

knob with the number or symbol representing the desired

washcycle.TheSTART/PAUSEindicatorlightwillflash.

6. Select the wash options*

(see Options).

7. Start the cycle by pressing the START button; the indicator

light will light up and remain lit in a fixed manner. The

indicator light corresponding to the wash phase will switch

on, signalling that the wash cycle has begun.

8. At the end of the wash cycle the END indicator light will

switch on (fixed light). Switch off the appliance by pressing

theON/OFFbutton,shutoffthewatervalveandunplugthe

appliance from the electricity socket.

9.Waitforafewminutesbeforeremovingthecrockery,in

order to avoid burns. Unload the racks, beginning with the

lower level.

- The machine will switch off automatically during

certain periods of inactivity, in order to minimise

electricity consumption.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it

has only just begun: once the wash cycle has started, switch

offthemachinebypressingandholdingtheON/OFF/Reset

button. Switch it back on using the same button and select

the desired wash cycle and options.

Adding extra crockery

PresstheStart/Pausebutton(thecorrespondingindicator

light will flash). Open the door, taking care to avoid

the escaping steam, and place the crockery inside the

appliance.PresstheStart/Pausebutton(fixedlight):thecycle

starts from the point at which it was interrupted.

IftheStart/Pausebuttonispressedsoastopausethe

machine, the wash cycle or the Delayed Start* function

(if selected) is interrupted.

At this stage it is not possible to change the wash cycle.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or once

the electricity supply is restored.