49
Odour formation in
the washing
machine.
Run Cotton 90 °C programme without washing.
Use standard detergent.
Repeated, intensive
foaming.
– Check basic dosage settings and dosage strength.
– If required, use a different liquid detergent.
Detergent/softener
drips off the seal and
collects on the door
or in the seal fold.
Too much detergent/softener in the dispensers. Observe max mark
in the dispensers.
i-Dos
iIô
presetting deleted.
If the i-Dos iIô: content menu setting is changed, all settings
are changed. ~ Page 35
Loud noise
formation, vibrations
and “wandering”
during spin cycle.
– Appliance aligned?
Align the appliance. ~ Page 61
– Appliance feet fixed?
Secure appliance feet. ~ Page 61
– Transportation safety devices removed?
Remove transportation protection devices. ~ Page 56
Display panel/
indicator lights do
not function while
the appliance is
running.
– Power failure?
– Fuse tripped? Switch on/replace fuse.
– If the fault occurs repeatedly, call customer service. ~ Page 50
The programme
takes longer than
usual.
– Not a fault – unbalanced load detection system adjusts
imbalance by repeatedly distributing the washing.
– Not a fault – foam detection system active – several rinse cycles
are switched on.
Detergent residue
on the washing.
– Occasionally phosphate-free detergents contain water-insoluble
residue.
– Select Rinsing or brush the laundry after washing.
In the pause status
Start/Reload
Ü
flashes very quickly
and a signal sounds.
– Water level too high. Washing cannot be reloaded. Immediately
close washing machine door.
– Select Start/Reload Ü to continue the programme.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the tap and call customer service. ~ Page 50
Faults Cause/Remedy
