10.4 Resetting the LAN (External Peripheral or Embedded) Ethernet Module
If the IQ LAN module is accidentally set to an incorrect (and/or unknown) IP address, it is possible
to reset the IQ LAN module to original default IP address.
1. Power off the IQ-400 board.
2. Reset SW1 DIPswitch to (11101110)
3. Power up the board. The IQ-400 board
LED Array will initially show 8.8., then
8.6., then 8.8. once again –board is now
reset. The board reset has created the
following default values:
a. Logon is “admin”
b. Password is “PYMTF”
c. “Host IP” is reset to ‘0’
d. “Our IP” is reset to 192.168.168.32
4. Using your Internet browser, type in the IP address 192.168.168.32. The IQ LAN
module should be in default mode.
NOTE Your computer’s TCP/IP has to be set to the 192.168.168.xxx for proper
communication to the panel.
5. See page 104, steps 5 through 8, for proper resetting of the TCP/IP configuration for
the board.
NOTE When reset, the LAN module will default to Panel 1 and the default
address.
end/
IQ-400 Installation Manual Page 99 of 100 33-10057-001-A
