SCION xA 2006 - SECURITY WITH RKE (V3)
Procedure
Page 7 of 22 pages
Issue: C 05/24/05
DIO
(i) Insert the terminal at the end of the vehicle
harness' RED wire into the female empty 1P
connector. (Fig. 3-5)
(1) Verify the correct opening is chosen.
(2) Verify the terminal is inserted and seated
properly.
(3) Close the retainer.
(4) The terminal should not come out when
pulled lightly from the back. If the
terminal comes off, then push it in more
securely.
(j) Plug in the V3 harness' white 1P male
connector into the V3 harness' white 1P
female connector. (Fig. 3-6)
(1) Verify connectors are plugged in
securely.
(2) Refit the diode to the vehicle harness' 3P
connector.
(k) Plug in the V3 harness' white 13P connectors
between the driver's side cowl area and the
vehicle harness' 13P connector. (Fig. 3-6)
(1) Verify connectors are plugged in securely.
(l) Plug in the V3 harness' white 18P connectors
between the driver's side cowl area and the
vehicle harness' 18P connector. (Fig. 3-6)
(1) Verify connectors are plugged in securely.
(m) Secure the vehicle harness' white 3P diode
connector and the V3 Harness' white 1P
connector to the vehicle harness using one
medium wire tie. (Fig. 3-7)
(n) Secure the 13P connectors and the V3
harness to the connector block with one large
wire tie. (Fig. 3-7)
(1) Arrange and secure the 13P connectors
under the connector block as shown.
(o) Secure the V3 harness to the vehicle harness
with one medium wire tie. (Fig. 3-7)
(p) Route and attach the V3 harness' relays to the
vehicle harness with two large wire ties.
(Fig. 3-8)
Fig. 3-8
Side Cutter
V3 Harness
Relays (x2)
Large Wire Ties (x2)
Fig. 3-7
Large Wire Tie
Side Cutter
13P
White
18P
White
1P (White)
3P
White
Medium Wire
Ties (x2)
Fig. 3-5
V3 Harness' RED Wire
V3 Harness
Vehicle Harness'
RED Wire
1P (Male)
1P (Female)
3P (White)
Retainer
Fig. 3-6
18P (White)
3P (White)
Diode
1P (White)
13P (White)
V3 Harness
