SCION xA 2006 - SECURITY WITH RKE (V3)
Procedure
Page 6 of 22 pages
Issue: C 05/24/05
DIO
3. V3 Harness Installation. (Driver Area)
(a) Locate the vehicle harness' white 3P diode
connector and remove the tape securing the
white 3P diode connector to the driver's side
cowl area. (Fig. 3-1)
(b) Locate and disconnect the white 13P and 18P
connectors from the driver's side cowl area.
(Fig. 3-1)
(c) Using a small flat blade screwdriver, remove
the diode from the white 3P diode connector.
(Fig. 3-1)
(1) Do not discard the diode.
(d) Using a small flat blade screwdriver, lift up
the terminal retainer on the white 3P diode
connector. (Fig. 3-2)
(e) Locate the RED wire in the right terminal
space. Using a jeweler's screwdriver, release
and pull out the RED wire. (Fig. 3-2)
(f) Insert the wire at the end of the V3 harness'
RED wire into the right terminal space of the
vehicle harness' white diode 3P connector.
(Fig. 3-3)
(1) Verify the correct opening is chosen.
(2) Verify the terminal is inserted and seated
properly.
(3) Close the retainer.
(4) The terminal should not come out when
pulled lightly from the back. If the
terminal comes off, then push it in more
securely.
(g) Disconnect the empty 1P female connector
plugged into the V3 harness' 1P male
connector. (Fig. 3-4)
(h) Using a small flat blade screwdriver, lift up
the terminal retainer on the back of the empty
1P connector. (Fig. 3-4)
Fig. 3-1
Small Flat Blade Screwdriver
Tape
Diode
3P (White)
18P (White)
13P (White)
Fig. 3-2
3P (White)
Retainer
Small Flat Blade Screwdriver, Jeweler's Screwdriver
Vehicle
Harness'
RED Wire
Fig. 3-3
V3 Harness' RED Wire
V3 Harness' 1P
3P (White)
Vehicle Harness'
RED Wire
Fig. 3-4
Small Flat Blade Screwdriver
1P (Female)
Retainer
1P (Male)
V3 Harness
