In the event of a service call at a later
date, any changes made to the factory
setting should be documented here.
Make a note of any changes made in
the “Value set:
” box.
1. Setting the cold water inlet from:
“Nominal water intake” to “Nominal
water intake+1l”.
The amount of water taken into the
machine at each intake can be increased
by 1 litre to a maximum of 9.5 litres.
Proceed as follows:
^ Turn the program selector to the f
“STOP” position.
^ Switch off the machine.
^ Press 4 and 6 at the same time, hold
them in and while doing so switch the
machine on with the I-0 button.
The current program status “P...”
appears in the display.
The p / 6 indicator light comes on.
^
Press 3 once, “E01" (programming
level 1) appears in the display.
^
Turn the program selector to the p
position,
“10" or ”11" appears in the display.
“10" = Nominal water intake
”11" = Nominal water intake +1l
^
Press 4 to change from “10" to ”11" or
vice versa.
^
Press 6. “SP” appears in the display.
^
Press 6 again. The change has been
recorded.
Value set:
2. Selecting a second interim rinse
A second interim rinse can be
programmed in to improve interim
rinsing in all programs (except D
COLD).
^
Turn the program selector to the f
“STOP” position.
^
Switch off the machine.
^
Press 4 and 6 at the same time,
hold them in and while doing so
switch the machine on with the I-0
button.
The current program status “P...”
appears in the display.
The p / 6 indicator light comes on.
^ Press 3 once, “E01" (programming
level 1) appears in the display.
^ Turn the program selector to r ,
“30" or ”31" appears in the display.
“30" = One interim rinse.
”31" = Two interim rinses.
^ Press 4 to change from “30" to ”31"
or vice versa.
^
Press 6. “SP” appears in the display.
^
Press 6 again. The change has
been recorded.
Value set:
Programming special functions
31
