Page 4 Sensor Mounting Arm
A
TTACHING
THE
M
OUNTING
B
RACKET
In order to attach the mounting bracket to the sensor arm, you will need the
sensor arm, mounting bracket, two #8-32 x 2-1/2” screws, four #8 flat washers,
two #8 split lock washers, and two #8-32 hex nuts.
1. Place one #8 flat washer over the end of each of the #8-32 x 2-1/2” screws.
2. Position the mounting bracket so the holes in the mounting bracket line up with the
appropriate holes on the sensor arm.
3. Slide each of the #8-32 x 2-1/2” screws (with washer) through the holes on the sensor
arm and the mounting bracket.
4. Secure the mounting bracket to the sensor arm using a #8 flat washer, #8 split lock
washer, and a #8-32 hex nut on each screw end.
Tighten until the mounting bracket is securely fastened to the sensor arm.
A
TTACHING
THE
M
OUNTING
B
RACKET
