
FE1/E1 Adapter Module
Supplement
6
302702-A Rev. 00
Completing the Installation
Before you can use the E1/FE1 WAN adapter module after installation, you must
start the router on the network and modify its configuration file to include the
E1/FE1 WAN interface.
• To start an AN or ANH router after installing the E1/FE1 WAN adapter
module, see
Installing and Operating BayStack AN and ANH Routers
. For an
ARN router, see
Installing and Operating BayStack ARN Routers
.
• To configure E1/FE1 WAN services, see
Configuring WAN Line Services
and
Configuring BayStack Remote Access.
Also, see any Release Notes or
Document Change Notice distributed with your upgrade kit.
Note:
The only boot/startup methods you can use from the E1/FE1 WAN
adapter module interface are Local Boot and EZ-Install. The E1/FE1 WAN
adapter module does not support Netboot or Directed Netboot.
Note:
Adding software for the WAN adapter module may increase the router’s
memory requirements beyond its current capacity. If the BayStack router
experiences a memory problem, see the section “Memory or Buffer Problem”
in
Troubleshooting Routers
. For information about changing the router image,
see
Configuring and Managing Routers with Site Manager
.