Troubleshooting
32
Washing has not been
spun well, there is
water left in the drum.
Error code
(2
appears.
There is a kink in the outlet
hose.
Eliminate the kink.
Maximum pumping height
(drain height 1m from the
position of the machine) is
exceeded.
Please contact AEG Service
Force Centre, it has a retro-
kit available for pump
heights above 1m.
Drain pump is blocked.
Switch off the machine and
pull the plug out of the
socket, clean the drain pump.
The water drainage system is
blocked.
Clean the blockage.
The door cannot be
opened with the
machine on.
The door is locked due to
safety reasons (DOOR
display is off).
Wait until the DOOR display
is green.
The rinse water is
cloudy.
Probably caused by a
washing powder with a high
silicate content.
This does not negatively
affect the rinse results. If
necessary use liquid
detergent.
When pressing an
program option
button the
corresponding display
does not light up.
The program option selected
is not available with the
program set.
Make another selection.
Washing powder
residues are left in the
washing powder
compartment.
The water tap is not fully
open.
Open the water tap fully.
The filter in the clamp of the
inlet hose is blocked.
Clean the filter.
The filter at the clamp
connection of the inlet hose
on the machine is blocked.
Clean the filter.
Fault Possible cause Remedy
263740.bk : 263740 Seite 32 Dienstag, Juni 17, 1997 11:59 AM
