Troubleshooting
31
Washing machine
vibrates during
operation or is
unsteady.
The machine is not level.
Adjust the feet according to
the installation and
connection instruction.
There is very little washing in
the machine (e.g. only a bath
robe).
This does not hinder the
machine from functioning
correctly.
Water could not be comple-
tely pumped out before the
spin
- because there is a kink in
the outlet hose or
the drain pump is blocked.
Check that the outlet hose is
correctly laid and if appli-
cable eliminate the kink or
clean the drain pump and if
necessary remove any
foreign bodies from the
pump housing.
The suds in the main
wash cycle create too
much foam.
Probably too much washing
powder was used.
Only use as much as the
washing powder manufac-
turer recommends.
Water is leaking out
from under the
washing machine.
The clamp on the inlet hose
is not tight.
Tighten the inlet hose clamp.
The inlet hose has a leak.
Check the inlet hose and if
necessary replace it.
The lid of the drain pump is
not correctly closed.
Close the lid correctly.
Washing is caught in the
door.
Abort the program, remove
the washing caught in the
door, start a new program.
Fabric softener is not
added, compartment
À
for fabric softener
is filled with water.
Suction cap in the
compartment for fabric
softener is not correctly
fitted or is blocked.
Clean the detergent
compartment, fit the
suction cap on firmly.
Fault Possible cause Remedy
263740.bk : 263740 Seite 31 Dienstag, Juni 17, 1997 11:59 AM
