28
Troubleshooting
Your washing machine was checked many times during manufacturing.
However, it is always possible that problems can arise. If so, please refer to the
following table before calling the After Sales Service.
User's instructions
There is no water in the washing machine
The washing machine will not fill
The washing is not properly clean
The wash cycle is too long
The machine stops during the wash cycle
The machine fills up and then drains
straight away
Softener pours through the overflow orifice
when filling
Check that :
- the water supply tap is fully open,
- the filter is not blocked.
Check that :
- the water supply tap is open and the pressure
is sufficiently high,
- the washing machine cover is properly closed,
- there is no power supply failure.
Check that :
- the detergent is suitable for machine washing,
- you have not tried to do too much washing
in one load,
- the washing program is appropriate.
Check that :
- the water pressure is high enough,
- the water inlet filter is not blocked,
- there is no power supply failure.
Check that :
-the water pressure is high enough,
- the water inlet filter is not blocked,
- fuses are in good condition and have not
tripped,
-the RINSE HOLD button is not pressed in.
Check that :
- the drain pipe is not attached too low.
Check that:
- you have not added too much softener,
- the siphons at the back of the product box
are not blocked.
Symptom
Solutions
