EZPi1000 User Manual
4-3. Installing the WLAN module
Screws for Ethernet module (set of 2)
Connection cable (module to
motherboard)
1. Make sure that the printer is switched off
and the power cord disconnected from the
printer. You should work on a clean, flat
surface.
Turn the printer upside down and remove
the two screws marked in the illustration
from the printer housing.
2. Place the printer the right way up again
and lift the printer cover.
3. To remove the top part of the printer
housing, gently pull the open printer cover
upwards.
4. Disconnect the connection cable from the
motherboard.
