GE Brand's Products

Installation Instructions

ADJUST HEIGHT AND LEVEL THE

ICE MAKER

Height adjustments may be necessary to install

the ice maker below a countertop, and may be

accomplished by adjusting both the front and rear

leveling legs. The ice maker must be level to operate

properly.

To level and adjust the height:

1. With one person holding the ice maker, carefully

tilt the machine to access the leveling legs.

 8VHDQDGMXVWDEOHZUHQFKWRWXUQWKHOHJV

– Turn legs right to lower, turn left to raise the ice

maker.

3. Check top and side with a level. Continue adjusting

legs until the ice maker is level and stable.

Raise Lower

WATER SUPPLY SET-UP

$FROGZDWHUVXSSO\

with water pressure

between 30 and

120 p.s.i. is required

for ice maker

operation.

7RDOORZVXȻFLHQW

ZDWHUÀRZWR

the ice maker, a

minimum 1/2”

diameter home

supply line is recommended.

5RXWH*(6PDUW&RQQHFW

™

Kit or 1/4” O.D. copper

tubing between house cold water line and the

water connection location.

7KHZDWHUOLQHVKRXOGEHORQJHQRXJKWRH[WHQGWR

the back of the ice maker when the unit is moved

forward for service.

,QVWDOOWXELQJRQO\LQDUHDVZKHUHWHPSHUDWXUHV

will remain above freezing.

7KHZDWHUOLQHVKRXOGEHIOXVKHGWRFOHDUDQ\

foreign material before connecting to the ice maker.

NOTE: The only GE approved plastic tubing is supplied

in the GE SmartConnect

™

Refrigerator Tubing kits.

Do not use any other plastic water supply line. The

line is under pressure at all times. Other types of

plastic may crack or rupture with age and cause

water damage to your home. Order parts below at

GEApplianceParts. com or by calling 1.800.626.2002.

GE SmartConnect

™

Refrigerator Tubing Kits are

available in the following lengths:

2’ (0.6 m) WX08X10002 15’ (4.6 m) WX08X10015

6’ (1.8 m) WX08X10006 25’ (7.6 m) WX08X10025

Tools and Parts Needed:

Gather the required tools and parts before starting

installation:

z Flat-blade screwdriver

z 7/16” and 1/2” open-end wrenches or two

adjustable wrenches

z 1/4” nut driver

z 1/4” (6.35 mm) soft copper or GE SmartConnect

™

tubing

NOTE: Do not use a piercing-type or 3/16” (4.76 mm)

VDGGOHYDOYHZKLFKUHGXFHVZDWHUÀRZDQGFORJV

more easily.