GE Brand's Products

Installation Instructions

REMOVE PACKAGING AND PARTS

/D\WKHFDUWRQRQUHDU

face and break open the

bottom flap.

6HWWKHFDUWRQXSULJKW

with all four bottom flaps

outward.

/LIWFDUWRQXSDQGRIILFH

maker.

5HPRYHDOOWDSHDQG

packaging material from the outside and inside

of the cabinet.

WATER FILTRATION SYSTEM

Install Water Filter

1. Locate the accessory packet in the ice maker and

remove the water filter.

2. Remove the cover from the water filter. Be sure the

O-rings are still in place after the cover is removed.

3. Locate the water filter compartment on the right-

hand side of the ice maker controls.

4. Align the alignment pin on the side of the filter

with the cutout channel in the control housing and

insert filter.

5. Turn filter clockwise until it locks into the housing.

NOTE: If the filter is not correctly locked into place,

the ice maker will not produce ice.

POWER SUPPLY

WARNING : (Please read carefully).

FOR PERSONAL SAFETY, THIS APPLIANCE MUST

BE PROPERLY GROUNDED. Failure to follow these

instructions can result in death, fire or electrical

shock.

AVERTISSEMENT :

(S’il vous lisez avec soin). POUR VOTRE SÉCURITÉ,

CET APPAREIL DOIT ÊTRE CORRECTEMENT MIS À

LA TERRE. Le non-respect de ces instructions peut

causer la mort, un incendie ou un choc électrique.

Do not use an extension cord or adapter plug with

this appliance. Follow National Electrical Code or

prevailing local codes and or di nanc es.

This ice maker must be supplied with 115V, 60Hz,

and connected to an individual, properly grounded

branch circuit, and protected by a 15 or 20 amp

circuit breaker or time delay fuse.

$SURSHUO\JURXQGHGWKUHHSURQJRXWOHWVKRXOGEH

located within reach of the ice maker’s 66” long

power cord. For a built-in installation, locate the

receptacle in the shaded area shown.

IMPORTANT: (Please read carefully).

The power cord of this appliance

is equipped with a three-prong

(ground ing) plug that mates with a

standard three-prong grounding wall

re cep ta cle to minimize the possibility

of electric shock. The customer

should have the wall receptacle and circuit checked

by a qualified electrician to make sure the re cep ta cle

is properly ground ed and has the correct polarity.

:KHUHDVWDQGDUGWZRSURQJZDOOUHFHSWDFOHLV

encountered, it is the personal re spon si bil i ty and

obligation of the customer to have it replaced with

a properly grounded three-prong wall receptacle.

Do not, under any circumstances, cut or remove

the third (ground) prong from the power cord.

DO NOT USE AN EXTENSION CORD.

Cover

O-Rings

Alignment Pin

Alignment

Arrow

8QORFNV\PERO

Alignment Pin

Lock symbol

Cutout channel in

control housing