25
7. Use special spanner A to remove the two screws
E.
8. Use special spanner A to remove the four screws F.
9. Remove the transit bar G.
10.Screw in the four screws F again.
11.Use sealing caps B to cap the two large holes.
Important: Press all sealing caps B (2 items) and C
(1 item) in firmly so that they snap into the rear wall.
(Splash protection)
Where to install
Important: The washing machine must not be oper-
ated in a room where there is a danger of frost. Risk
of frost damage or function may be impaired. Frost
damage is not covered under the warranty.
• The surface on which the appliance is to be in-
stalled must be firm and level. Do not install the
appliance on carpeted floors or soft floor cover-
ings.
• The surface on which the washing machine is to be
installed must be clean and dry and free from floor
polish residue and other greasy coatings so that
the appliance does not slip.
• If the surface on which the appliance is to be in-
stalled is covered with small tiles, place commer-
cially available small rubber mats under the stands.
If the appliance is to stand on a base:
In order for the appliance to be secure on the base,
fixing plates*) must be mounted, into which the ap-
pliance is inserted.
If the appliance is to stand on floors that
vibrate, e. g., floors of wooden joists with
deal boards:
Place the appliance in an area as close as possible
to a corner of the room.
1. Screw a water-resistant wooden board (at least 15
mm thick) onto at least 2 of the floor joists.
2. Fit mounting plates*) to the wooden board, into
which the appliance will then be inserted.
*) The mounting plates are available from the Cus-
tomer Service Centre.
