
15
WATER DRAIN
ELECTRICAL CONNECTION
Three types of drain hose connections are possible.
a) Directly into drainage standpipe
Hook the free end of drain hose reinforced by plastic
support into the drain pipe with inner diameter 3 cm
minimum. The end of the drain hose has to be 55 cm
min. from the floor.
b) Drainage into a sink
Hook the end of the drain hose to a sink or wash
basin and fix the support to avoid hose falling down
by water pressure or pulled accidentally by children.
The drain of wash basin (sink) has to be fast enough -
not to overflow water.
c) Drainage into a sink siphon
If there is a socket for drain hose connection on the
sink or wash basin, it is possible to connect the drain
hose. Make sure that the height is min. 55 cm from
the floor.
This product is intended for connection to electrical
network 220 - 230 V/50Hz protected by a 10 ampere
fuse, fixed up by plug with earth connection. This
washer meets the requirements of European Economic
Community 87/308/EEC and all following international
standards and regulations.
The Electrical installation has to be installed according
to Local Regulations. If the washer is placed in wet
environment (laundry, bathroom), it has to be protected
by effective earth connection - all metallic parts in the
room, which may come in contact with the washing
machine must be properly connected to avoid any
hasards.
Appliances installed in rooms with a bath or a shower
must be protected by a multiple device of 30 mA
minimum.
A special inlet cable is used for this washing machine. If
necessary, it can be replaced only by the brand service
and the original inlet cable must be used - ordering
number of a spare part 481932118292 .
All repairs can only be carried out by trained and
licensed technicians. Before each intervention to the
washer it has to be disconnected from electrical
network by pulling out the plug from the mains.
Manufacturer is not responsible for damage and
injury caused by breaking these regulations.