
14
HOW TO REMOVE THE TRANSPORT BRACKETS
WATER CONNECTION
1. Unpack the washing machine following the
instructions illustrated on the top package.
2. Tilt the washing machine backwards and remove the
polystyrene plinth. Be sure to also remove the black
plastic cone located at the bottom of the packaging.
This cone must not remain in the washing
machine.
3. Remove the metal transport bracket fixing the tub
during transport.
· Unscrew the two screws A with a flat screwdriver
or a N° 8 pipe wrench.
· Unscrew the four screws B with the same
screwdriver or with the pipe wrench and remove
the transport bracket.
4. Remove the two gray rectangular stop plugs C from
the drain hose support and clip them into the
openings D .
Connect the inlet hose to a cold water tap with
outer thread G 3/4. Screw the inlet hose connector
firmly by hand into the tap. Do not use adjustable
wrench.
Water tap has to be completely opened during the
washer operation.
Water pressure should be from 0.05 - 1.00 Mpa
(0.5 - 10 atm)
If your water pressure is very high or very low, or if
you encounter any other problem, consult a
qualified plumber.
INSTALLATION
Notice:
We recommend to not position the washing machine on carpet or other floors that would obstruction the
proper ventilation through the bottom of the machine.
Should the machine be installed in a room which is subject to temperatures under 0°C, you need to empty water at
the end of each wash cycle.
Please follow the instructions given in chapter Cleaning the drain pump and disconnect the water inlet hose.