---- METHOD 1 FOR ENTERING SECURITY CODE--------------------------------------------------------------------------------------------
METHOD 1 AFFECTS SOME VEHICLES WITH FOLLOWING NUMBER OF KEYS INSIDE PLIP:
- 7 KEYS STARTING WITH: P, V, R (V1 DUAL DECODER) or W (V2 DUAL DECODER)
- 8 KEYS STARTING WITH: Y (V2 SINGLE DECODER)
MODELS:
- TWINGO 01/95 upto CARD (some is still affected to METHOD 2)
- CLIO 07/94 - 01/96 (some is still affected to METHOD 2)
- R19 05/93 - END
- R21 01/92 - END
- LAGUNA 02/94 - 05/95
- SAFRANE 01/93 - 10/95
! LAGUNA, SAFRANE WITH VOICE SYNTHESIZER: USE VOICE SYNTH. BUTTON (NOT TRIP C. BUTTON)
ALL OTHER VEHICLES -AND ALL VEHICLES WITH KRS -REFER TO METHOD 2 OR DIAGNOSTIC TOOL
1. Doors closed, Ignition ON (Injection Warning Light (V1) or IMMOLED (V2) flashes if starting is blocked)
2. Press down the accelerator pedal (Injection Warning Light (V1) or IMMOLED (V2) will extinguish)
3. Press the Trip Computer button the number of times as the first digit in security code (4 = 4 presses)
The Injection Warning Light or IMMOLED will light up each time the button is pressed
4. Release the accelerator pedal when first digit is finished, injection warning light or IMMOLED flashes
5. Repeat step 2-4 untill the security code is finished. The vehicle can now be started if the code was correct.
Do not start if you are resynchronising keys, switch OFF ignition
and proceed to METHOD FOR RESYNCHRONISING KEYS within 10 seconds
---- METHOD 2 FOR ENTERING SECURITY CODE --------------------------------------------------------------------------------------------
1. Doors closed, Ignition ON – The Injection Warning Light will illuminate for 3 seconds followied by rapid flashing
of IMMOLED if the immobiliser is unable to accept the key and starting is blocked.
2. Press and hold the CDLB for 5 seconds, IMMOLED will go off, come back on and begin to flash slowly.
The flashes correspond to the first digit of the 4 PIN security code, 4 flashes = number 4
Release the CDLB when the first digit has been "flashed" and then press the CDLB again and wait
for the second digit to be "flashed" before you release CDLB again.
3. Continue until all digits have been entered.
4. If you have entered the code correctly the IMMOLED will illiminate for 3 seconds then go out for 3 seconds
and then illuminate for 30 seconds (on most vehicles). The vehicle can now be started. Do not start if you are
resynchronising keys, switch OFF ign. and proceed to METHOD FOR RESYNCHRONISING KEYS within 10 seconds
---- END ------------------------------------------------------------------------------------------------------------------------------------------------------
IF NONE OF THE ABOVE METHODS WORK
YOU ARE REQUIRED TO USE A SUITED DIAGNOSTIC TOOL TO ENTER THE SECURITY CODE.
VDIAG.COM
