3. 4.
Frost precautions
If the appliance is installed in an area where
the temperature can be less than 0 °C,
remove the remaining water from the inlet
hose and the drain pump.
Do this procedure also when
you want to do the emergency
drain.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the water inlet hose.
4. Remove the drain hose from the rear
support and unhook it from sink or
spigot.
5. Put the ends of the drain and inlet hose
in a container. Let the water flow out of
the hoses.
6. When no more water flows, install the
inlet hose and the drain hose again.
WARNING! Make sure that the
temperature is more than 0 °C
before you use the appliance
again. The manufacturer is not
responsible for damages caused
by low temperatures.
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
Introduction
The start of the appliance does not occur or
it stops during operation.
17
