[ pg. 7]
Front Panel
Components
Description
Power LED This LED goes ON when the power is being supplied to the router.
WLAN LED This LED goes ON when the RF (wireless LAN) feature is enabled.
WAN LED This LED goes ON when an Ethernet cable is connected to the router’s WAN port.
LAN (1 – 4 ) LEDs These LEDs go ON when an Ethernet cable is connected to the corresponding router LAN port.
WPS button
Press 1-to 5 seconds to activate the router’s Wi-Fi Protected Setup (WPS) feature.
Press 6-to-10 seconds to reboot the router.
Press 11 seconds or longer to reset the router to its default settings.
Back Panel
Components
Description
LAN Ports (1 – 4) Use an Ethernet cable to connect each port to a computer on your Local Area Network (LAN).
WAN /Internet Port Use an Ethernet cable to connect this port to a cable or DSL modem.
DC-Jack (POWER) Connect the power adapter to this connector.
Power Switch Turns the router on or off.
Antenna Connector Interface for the antennas.
