7
Lit. No. 63617
September 13, 2002
UNDERHOOD INSTALLATION
VEHICLE HARNESS AND MOTOR RELAY
Except as noted, parts to be installed are found in the
hydraulics box.
NOTE: Use dielectric grease on all electrical
connections to prevent corrosion. Fill
receptacles and lightly coat ring terminals and
blades before assembling.
1. Identify wires for the parking lamp on the driver side
and the turn signals on both sides of the vehicle.
Attach a black self-stripping bullet receptacle
connector (found in harness kit) to each of these
three wires.
CAUTION
Batteries normally produce explosive gases,
which can cause personal injury. Therefore, do
not allow flames, sparks or lit tobacco to come
near the battery. When charging or working
near a battery, always cover your face and
protect your eyes, and also provide ventilation.
Batteries contain sulfuric acid that burns skin,
eyes and clothing.
Disconnect the battery before removing or
replacing any electrical components.
(continued on next page)
HARNESS, SOLENOID CONTROL AND MOTOR RELAY INSTALLATION DIAGRAM
2. Remove NEGATIVE battery cable from battery.
