6
Lit. No. 63617
September 13, 2002
SOLENOID CONTROL INSTALLATION
Solenoid Control
Control Bracket
Cable Clamp
#8-32 x 3/8"
Thread Cutting
Tapping Screw
Dash Bracket Ho
See Step 2
Dash Bracket Ho
See Step 1
#8-32 x 3/8" Hex Head
Thread Cutting Screw
#8 Spring Lock Washer
Dash Bracket
10 x 1" Sheet
etal Screws
10 Lock Washers
#8 x 5/8" Hex Head
Tapping Screws
SOLENOID CONTROL - FLOOR MOUNTED
INSTALLATION INSTRUCTIONS
1. Align dash bracket hole shown in diagram to end
hole of control bracket.
NOTE: Top flange of control bracket may be
reversed in dash bracket from position shown
in diagram. Attach with one #8 x 3/8" hex head
thread cutting screw and lock washer on each
side.
2. Use top holes in dash bracket (see diagram) as a
template to drill a 9/64" hole in each side of control
bracket. Secure dash bracket to control bracket
with a second screw and lock washer in each side.
3. Secure solenoid control to control bracket with two
#8 x 5/8" hex head tapping screws.
4. Move seat forward. Locate control and bracket
assembly on floor tunnel so that it does not
interfere with the operation of vehicle controls.
Mark this location.
5. Remove control bracket from dash bracket.
6. Place dash bracket in marked location. Use dash
bracket as a template to drill four 1/8’’ holes in
tunnel.
NOTE: Before drilling any holes, check both
sides of the material for any wires, fuel lines,
fuel tanks, etc. that may be damaged by drilling.
7. Secure dash bracket to tunnel with four #10 x 1"
sheet metal screws and lock washers.
8. Reassemble control bracket to dash bracket. Bend
top flange of control bracket to desired position.
9. Secure harness to control bracket with cable clamp
and one #8 x 3/8" hex head thread cutting screw.
