TMA; Reviewed:
SPOC 6/19/2008
Solution & Interoperability Test Lab Application Notes
©2008 Avaya Inc. All Rights Reserved.
6 of 24
AW-i75-APP-50
2. From the SAT interface use the “change off-pbx-telephone feature-name-extensions”
command to configure the following parameters on page 1 and Submit the changes. Note that
the extensions used for FNEs match those used for FACs by pre-pending the FAC code with
“710”. Having this uniformity between FACs and FNEs is recommended but not required.
change off-pbx-telephone feature-name-extensions Page 1 of 2
EXTENSIONS TO CALL WHICH ACTIVATE FEATURES BY NAME
Active Appearance Select:
Automatic Call Back:
Automatic Call-Back Cancel:
Call Forward All: 71016
Call Forward Busy/No Answer: 71015
Call Forward Cancel: 71017
Call Park: 71010
Call Park Answer Back: 71011
Call Pick-Up: 71012
Calling Number Block:
Calling Number Unblock:
Conference on Answer:
Directed Call Pick-Up:
Drop Last Added Party:
Exclusion (Toggle On/Off):
Extended Group Call Pickup:
Held Appearance Select:
ESC-x=Cancel Esc-e=Submit Esc-p=Prev Pg Esc-n=Next Pg Esc-h=Help
3. In order for the FACs and FNEs to be routed through the system properly, the digits used for
Auto Route Selection (ARS), Auto Alternate Routing (AAR) and FACs need to be
administered in the dial plan. From the SAT interface on Avaya Communication Manager use
the “change dialplan analysis” command to configure the following parameters on Page 1
and Submit the change. The values specified for the “Dialed String” field value must match the
nes configured in Step 1 for AAR and ARS.
o
change dialplan analysis Page 1 of 12
DIAL PLAN ANALYSIS TABLE
Percent Full: 3
Dialed Total Call Dialed Total Call Dialed Total Call
String Length Type String Length Type String Length Type
60 2 fac
61 2 fac
# 3 fac
ESC-x=Cancel Esc-e=Submit Esc-p=Prev Pg Esc-n=Next Pg Esc-h=Help
