27What to do if…
What to do if…
Remedying small malfunctions
Before you call the Customer Care Department, please check whether
– you cannot remedy the fault yourself with the help of the following fault ta
ble
or
– whether it is caused by faulty, electrical connections and/or faulty water con
nections.
In these cases the engineer must make you liable for the costs of the Customer
Service intervention even during the warranty period.
If the acoustic signal is activated, warning tones sound if there are faults.
If while the appliance is operating indicators on the control panel flash or are lit
up as described in the following table, please consult this to find out how to
remedy the fault.
After remedying the fault that is flashing in the first or second rhythm in the
programme progress display, press the button for the dishwashing cycle that
had already started. The cycle will continue.
In the case of other fault messages:
– Cancel the dishwashing cycle.
– Switch the appliance off and on again.
– Select dishwashing cycle.
If the fault is displayed again, please contact the Customer Care Department
and inform them of the fault message.
Malfunction Possible cause Remedy
1 short warning tone, con
tinuously repeated, can be
heard,
the programme display for
the selected wash programme
is flashing:
the indicator for the end of
the wash programme is flash
ing once continuously .
(problems with water inflow).
Tap is blocked with limescale or
is faulty.
Check the tap and have it re
paired, if necessary.
The tap is turned off. Turn on the tap.
The filter (where present) in the
threaded hose fitting on the
tap is blocked.
Clean the filter in the threaded
hose fitting.
Filters in the base of the wash
ing compartment are blocked.
Cancel the dishwashing cycle
(see chapter: Starting a dish
washing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing cy
cle again.
Water inflow hose has not
been correctly positioned.
Check the position of the hose.
