14
ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
How to load your dishes
First of all.
Before placing the dishes in the
racks, remove the largest scraps
of food left over on your plates, you
will thus avoid blocking the filter,
which would reduce the efficacy
of the wash.
If the saucepans and frying pans
are very dirty, allow them to soak
before being washed. To make it
easier to load your dishes, pull the
racks out.
What goes into the
lower rack?
We recommend you place the most
difficult dishes to wash into the
lower rack: saucepans, lids, soup
dishes and plates (a load example
is shown in the photo).
Serving dishes and large
lids: place them on the sides
of the rack.
Saucepans, salad bowls:
must always be placed upside
down
Very deep dishes: place
them obliquely, thus allowing
water to run down them and
cleaning them better
The lower rack has tip-up sectors
(see figure B), so you can place
even more saucepans and frying
pans or make room for the larger
ones.
The cutlery basket can be split up
(see figure A): when you only have
little cutlery to wash, you can use
just half the basket. Save space
for the saucepans or you can place
the other half of the basket in the
upper rack instead. This basket is
equipped with two removable grids:
insert the cutlery one by one into
the slots, with the handles at the
bottom.
Before washing, a few small steps can help you get a better wash and keep your dishwasher for longer.
Remove the largest scraps of food left over on your plates, soak saucepans and frying pans with tough
incrustations. After loading your dishes, make sure the blades on the sprayer arm turn well.Do not
place glasses and cups on top of one another, and make sure the dishes are not touching.
upper rack
lower rack
12 standard place-settings
load
upper rack
lower rack
Daily load
Knives and utensils with sharp
blades or tips should be positioned
with the sharp parts at the
bottom.Position them so that they
don't touch.
After loading the dishes, remember
to check that the blades on the
sprayer arms can turn freely
without hitting against any dishes.
What goes into the
upper rack?
Place delicate and lightweight
dishes in the upper rack: glasses,
tea cups and coffee cups, saucers -
but plates too - shallow salad bowls,
slightly dirty frying pans and
shallow pans.
Position lightweight dishes in such
as way as to avoid their being
moved by the spray of water.
How to adjust the top
rack.
The upper rack can be set in high
or low position to enable you to
organise your dishes effortlessly.
Open the rail stop flaps and pull the
rack out completely. Now place it in
high or low position, then slide it
along the guide rails until the front
wheels also go in. Now close the rail
stop flaps. Follow the sequence of
actions illustrated in figure "F".
Fig.F
1
2
3
4
1
2
Fig.B
A
