Productos de la Marca Whirlpool

TROUBLESHOOTING

Your washing machine is equipped with various automatic

safety and feedback functions. They enable failures

and needed maintenance to be detected and indicated

accordingly.

Anomalies: Possible causes / Solution:

The washing machine does not

turn on.

The wash cycle does not start.

The washing machine does not

fill with water (the message “h2o”

is shown on the display). “Beep”

sound every 5 seconds.

The washing machine loads and

drains water continuously.

The washing machine does not

drain or does not spin.

Too much foam is formed.

Door is locked, with or without failure

indication, and the programme does

not run.

The washing machine vibrates

excessively during the spin cycle.

The washing machine leaks water.

The machine is locked and the

display flashe , indicating an error

code (e .g . F-01, F- . .).

These failures are frequently so minor that they can be

removed within a few minutes.

• Theplugisnotinsertedintotheelectricaloutlet,ornotenoughtomakecontact.

• Therehasbeenapowerfailure.

• Thedoorisnotfullyclosed.

• The“ON/OFF”buttonhasnotbeenpressed.

• The“Start/Pause” buttonhasnotbeenpressed.

• Thewatertapisnotopen.

• A“Startdelay”hasbeenset.

• Thewaterintakehoseisnotconnectedtothetap.

• Thehoseisbent.

• Thewatertapisnotopen.

• Themainswatersupplyhasbeenshuto.

• Thereisnotenoughpressure.

• Theprogrammedoesnotincludethedrainingfunction:withcertainprogrammes

it must be activated manually.

• Thedrainhoseisbent.

• Thedrainlineisobstructed.

• Thedetergentisnotcompatiblewiththewashingmachine(itmustbearthe

wording “for washing machines”, “for hand washing and washing machines”, or

something similar).

• Thedosagewasexcessive.

• Atthetimeofinstallation,thedrumwasnotproperlyunblocked.

• Thewashingmachineisnotlevel.

• Thewashingmachineissqueezedbetweenfurnitureandthewall.

• Thewaterintakehosehasnotbeentightenedproperly.

• Thedetergentdispenserisclogged.

• Thedrainhosehasnotbeenproperlyfastened.

• Shutoffthemachine,disconnecttheplugfromtheoutlet,andwaitabout1

minute before turning it back on.

• Iftheproblempersists,calltheAfter-salesservice.

• Doorislockedincaseofpowerbreakdown.Programmewillcontinueautomatically

as soon as the mains is available again.

• Washingmachineisinastandstill.Programmewillcontinueautomatically

after the origin of the standstill does not persist anymore.

• The“Start/Pause” buttonhasnotbeenpressed.

• Thedrainhosehasnotbeeninstalledat65to100cmfromtheground.

• Theendofthedrainhoseisimmersedinwater.

• Thedrainconnectoronthewalldoesnothaveanairvent.

• Iftheproblempersistsafterhavingperformedthesechecks,closethewatertap,

shut off the washing machine, and call the After-sales service. If the dwelling

is located on one of the uppermost floors of a building, a siphon eect can

sometimes occur, thus causing the washing machine to load and drain water

continuously. Special anti-siphon valves are available on the market to prevent

these types of problems.

User manual