EN
15
User manual
CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER
6.
Remove the kick panel: Using
a screwdriver, do that which
is shown in the following figure.
7. Container for the drained water:
Place a low and wide container under the water filter
in order to collect the residual water.
8. Drain the water:
Slowly turn the filt
er counter-clockwise until all the
water
has
come out. Allow the water to flow out without
removing the filter. Once the container is full, close the
water filter by turning it clockwise. Empty the container.
Repeat the procedure until all the water has been
drained.
9.
Removefilter:Lay acotton
clothbeneath thewaterfilter,
which can absorb a small amount of rest water. Then
remove the water fil er by turning it out anticlockwise.
10.
Clean the water fil
ter: remove residues in the filter and
clean it under running water.
11.
Insert the water filter and reinstall the plinth: Reinsert
the
water filter again by turning it in clockwise direction.
Make sure to turn it in as far as it goes; the filter handle
must be in vertical position. To test water tightness of
the water filter, you can pour about 1 liter of water into
the detergent dispenser. Then reinstall the plinth.
Switch off and unplug the washing machine before cleaning the water filter or draining residual water. If you used
a hot wash programme, wait until the water has cooled down before draining any water.
Clean the water filter regularly, to avoid that the water cannot drain after the wash due to obstruction of the filter.
If the water cannot drain, the display indicates that that the water filter may be clogged.
