75
INSTALLATION
Remove the transit screws
The appliance is fitted with two transit screws and a transit bar to
prevent internal damage while it is being moved.
Before using the appliance the transit screws and transit
bar MUST be removed.
The appliance is fitted with two screws and a transit bar.
1.Remove the black screw
(A)
with a screwdriver.
2.Unscrew the screw
(B)
on the red transit bar with a
screwdriver.
3.Completely withdraw and remove the transit bar
(C)
by pulling
firmly on the red handle.
Keep the screws and the bar for future use.
Note:
Refit the transit screws and transit bar before transporting
the appliance by repeating the above steps in reverse order. In
order to locate the screws and bar correctly, it will be necessary
to remove the appliance top, having first made sure that the
appliance is disconnected from water and electricity supplies.
Adjust the feet
If the floor is uneven, adjust the levelling feet as required (do not
insert pieces of wood etc. under the feet):
• Adjust the right foot by turning it by hand to assure that all four
feet touch properly the floor.
If the appliance is to be installed on a wooden floor, distribute the
weight by placing it on a 60 x 60 cm sheet of plywood at least 3 cm
in thickness.
Secure the plywood sheet to the floor.
5gb10030.fm5 Page 75 Thursday, July 18, 2002 9:58 AM
Black Process Plate
