- Bend retaining tabs of radial compensation to side using
a screwdriver and pull off support ring from fuel injector.
- Screw hammer T10133/3 to puller T10133/2 . Then
guide puller T10133/2 into groove on fuel injector and
carefully tap fuel injector out. It is possible that this will
destroy the radial compensation (retaining tabs break).
This must be replaced when re-installing fuel injector.
Installing
Note:
The Teflon sealing ring of fuel injector may not be
oiled or greased.
Possibly an opened intake valve hinders the
cleaning. In this case, engine must be turned further
by hand using a screw wrench on the crankshaft.
Ст
. 19 из 23Fuel in
ection s
stem
