Installation Instructions
POSITION WATER LINE
AND HOUSE WIRING
Position water supply line and house wiring on the
floor ofthe opening to avoid interference with base of
dishwasher and components under dishwasher.
Water
Line
House
Wiring
5"
5"
4"
4"
6"
6"
4"
INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or has
a factory installed power cord.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or
local codes and ordinances.
Be sure power is turned off at the source.
Upright the dishwasher and position in the front of
opening. Insert drain hose into cabinet wall hole.
If a power cord is used, guide the end through a
separate hole.
Connect the water line of dishwasher into user water line.
INSERT DRAIN HOSE AND
CONNECT WATER LINE
5
Figure 14
White
Ground
Black
Use UL Listed
Wire Nuts
D
Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
B
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
C
Remove
Junction Box
Cover
A
Figure 12
Figure 13
1. Remove junction box cover.
2. Secure house wiring to the back of the junction
box with a strain relief.
3. Connect incoming power cord white (or ribbed) to
dishwasher white, black (or smooth) to black and
Ground to green wire. Use UL listed wire nuts of
appropriate size.
4. Replace junction box cover. Check to be sure
that wires are not pinched under the cover.
WARNING!
If house wiring is not 2-wire with ground, a ground must
be provided by the installer . When house wiring is
aluminum, be sure to use UL Listed anti-oxidant
compound and aluminum -to-copper Connectors
