Installation Instructions
PREPARE WATER LINE
The line may enter from either side, rear or floor within
the shaded area.
WATER LINE CONNECTION
The line may pass through the same hole as the electrical
cable and drain hose. Or cut an additional hole of 1-1/2”
max.
Note: Power cords with plug must pass through a
separate hole.
* Turn off the water supply.
* Install a hand shut-off valve in an accessible
location, such as under the sink. (Optional but
strongly recommended.)
* Water connection is on the left side of the dishwasher.
Install the hot water inlet line, using no less than 3/8¡
O.D. Copper tubing. Route the line as shown and extend
forward at least 19” from rear wall.
* Flush water line to clean out debris.
* The water pressure must be 20-120 PSI.
To check door balance, hold the top of the dishwasher
firmly. Open the door slowly, if the door drops when
released, increase spring tension. If the door closes
when released, decrease tension.
6"
5"
5"
4"
Cabinet Face
Shut-off
Valve
4"
2" From Floor
19" From Wall
2"
From
Cabinet
1-1/2" Dia.
Hole
Hot
Increase
Spring
Tension
Decrease
Spring
Tension
ADJUSTMENT
If door does not open easily or falls too quickly, you
should adjust the tension of door spring:
Pull the spring adjustment pin out of the holes, insert
it in the next highest or lowest hole and test again.
Continue moving the spring pin until door is balanced.
Remove the two screws to remove toekick.
REMOVE TOEKICK
ADJUST DOOR BALANCE
4
Figure 9
Figure 10
Figure 11
Note to Consumer
This dishwasher can use both hot or cold water.
