English - 12
5. Connect the water supply hose to the adaptor. If you push
part (D) into the adaptor, the hose automatically connects to
the adaptor with a clicking sound.
After connecting the water supply hose to the adaptor,
ensure that it is connected correctly by pulling the water
supply hose downwards.
WARNING: Check if the water supply hose is not
twisted or bent. If the hose is twisted or bent, water may
leak, causing electric shock. If necessary, straighten
the water supply hose by loosening the L-shaped arm
fitting, rotating the hose, and retightening the L-shaped
arm fitting.
6. Open the water tap and ensure that no water leaks from the
water supply intake, water tap or adaptor. If you encounter a
water leak, repeat the steps above.
WARNING: In case of a water leak, stop using the
washing machine. Otherwise, this may result in electric
shock.
If the water tap is of the screw type, connect the water
supply hose to the tap as shown.
Use the most conventional type of tap for the water supply.
If the tap is square or too big, remove the space ring before
inserting the adaptor into the tap.
To connect the hot water supply hose (applicable models only)
1. Connect the red L-shaped arm fitting for the hot water supply
hose to the hot water supply intake at the upper rear side of
the washing machine. Then tighten it by manually turning part
(A) clockwise.
2. Connect the other end of the hot water supply hose to the
hot water tap in the same way as you connected the cold
water supply hose.
To use only cold water, use the Y-piece.
Untitled-1 12 2014-11-26 4:21:16
