Chapter 3 - Software Loading and Configuration
MTASR3
23
Note: Unlike the Ethernet port, the WAN ports do not have the capability of learning the network
number (i.e., the WAN ports do not have a file server).
18. Click OK when you are satisfied with your selections.
19. If you clicked OK from the Novell IPX Protocol Default Setup dialog box (step 13), the IP Protocol
Default Setup dialog box is now displayed.
20. To change the IP parameters, proceed to the next step. Otherwise, click OK to open the WAN Ports
Default Setup dialog box, then advance to step 23.
21. The default Ethernet IP Address has to be changed to your unique LAN address. In the Ethernet
group, change the default IP Address, Subnet Mask, and Frame Type to the values assigned to
your LAN port.
22. For any WAN ports that are enabled, enter the Address, Subnet, and Remote Address numbers.
23. Click OK when you are satisfied with your selections.
24. The WAN Ports Default Setup dialog box appears with all three WAN Ports enabled, the speed set
at 115200, and the Modem Type defaulted to Multi-Tech 56K Socket Modem.
25. If any WAN port is being set up to answer a call, click its Answering check box to enable it;
otherwise, (i.e., for dial-out ports) enter the telephone number to be dialed in the Dial Number field.
26. Click OK when you are satisfied with your selections.
27. The Checking Router dialog box is displayed. Click OK.
Next, the Writing Setup dialog box (with the current date and the file size in bytes) is displayed as
the software sends the configuration file to the RouteFinder.
