RouteFinder MTASR3 User Guide
MTASR3
14
Introduction
This chapter is organized in the way you will unpack and cable your RouteFinder. The unpacking
section describes the contents of the shipping box and shows how the RouteFinder is packaged. The
installation procedure describes each cable connection and shows where that cable is connected to
the RouteFinder. If additional RAM is needed on your RouteFinder, a detailed procedure is provided
describing how to install a second SIMM.
Safety Warning
1. Never install telephone wiring during a lighting storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3. This product is to be used with UL and cUL listed computers.
4. Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
5. Use caution when installing or modifying telephone lines.
6. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electrical shock from lightning.
7. Do not use the telephone to report a gas leak in the vicinity of the leak.
Unpacking
The shipping box contains the RouteFinder, external power supply, a plastic bag containing cables,
your Quick Start Guide, and two disks (i.e., the RouteFinder User Guide, and the RouteFinder
Software). Inspect the contents for signs of any shipping damage. If damage is observed, do not
power up the unit; contact Multi-Tech’s Technical Support for advice (refer to Chapter 7). If no
damage is observed, place the RouteFinder in its final location and perform the Installation Procedure
in Table 2-1.
Save the shipping box in case reshipment is necessary.
MADE IN U.S.A
MADE IN U.S.A
T
e
c
h
Systems
Æ
Figure 2-1. Unpacking
