42
The control panel –
1. Programme guide
2. Mains-on light: The light illuminates when the machine stars working and goes
out when the on/off button is released.
3. On/off button: By depressing this button the machine starts operating. When de-
pressed again, the machine stops.
Rinse hold button: Press this button to make the machine stop with water in
the drum after the cotton, synthetic or delicate wash cycles. This prevents any creas-
ing which may take place if the clothes are left damp in the drum. When it is con-
venient for you to empty the machine, simply press this button again so that the
machine can proceed to drain and spin, or turn the dial to the drail
4. programme “13”.
5. Half load button: Select this button to reduce water consumption on the rinse
cycle when washing a smaller load of cottons or linens.
6. Programme selector dial: Turn the dial clockwise to select the required wash
programme. Before setting the dial to any position the machine must be switched
off by depressing the on/off button again.
Operating sequence-
• Load the laundry
• Measure out the detergent
• Measure out the fabric softener
• Select the required option i.e. rinse hold or half load
• Select the required programme
11
LP711:Timeswitches
A 7 day program, allowing for different timings on each day of the week, up to 3 heating
periods each day.
Want to leave a timing as it is? Just press SET and move on to the next one.
If you need to reset your timings to the standard program and start again, press SET and +
together to go back to the pre-set program.
The system will come on for up to 3 heating periods every 24hrs. ON1 starts the first one.
OFF1 finishes it, and so on. Notice that ON2 and OFF2 are set to the same time. This
means that your system won’t respond, but if you want to activate that middle period or
any change any other timing – read on.
Changing the timings-
• Press the SET? button and you’ll see SET PROG?
Set all weekdays-
First you set the times that are going to be the same for each weekday, then you can select
each day individually and make any further adjustments. If you want each day to be quite
different, go straight to Set each day.
