6
INSTALLATION
WATER CONNECTION
The machine is plumbed in with the connection
hose that comes with it. The water pressure shall
be 0.1-1MPa (approx. 1-10kp/cm2 ; 10-100N/
cm2).
The water supply must have a stop cock. If the
piping is new, it can be advisable to first thorough-
ly flush it through so that any dirt will be flushed
out. Otherwise, any dirt in the piping could block
the filter in the machine's inlet valve and stop the
water supply.
WATER INTAKE – MIXED OR COLD WATER
On delivery the machine is set to use mixed hot
and cold water (E).
Machines with the US programme are set to use
both warm and cold water (H):
P1-P3: Warm water intake.
P4-P6: Mixed warm and cold water intake
P7-P8: Cold water intake.
To change the water intake setting, do as
follows:
Switch off the power switch, , then switch it
on again so that the machine is in start-up mode.
Press the
P8
button five times, then press the
P4
button five times. You have to complete the-
se ten button presses within fifteen seconds.
Within three seconds of pressing the
P4
but-
ton for the fifth time you must then select the
type of water intake you want by pressing the
P6
,
P7
or
P8
buttons.
P6
to use cold water intake only (C).
P7
for US intake, see above (H). Could only be
used on machines with US programme.
P8
to use mixed hot and cold water (E).
A letter C near the bottom right of the display
shows that cold water is being used, H shows the
intake for US mentioned above and the letter E
indicates mixed hot and cold.
