20
TEST PROGRAM AND FAULT INDICATIONS
TEST PROGRAM
Press
P1
5 times within 15 seconds to start test
program level 1.
Press one time on
P8
to reach level 2. Press
P8
again to go back to level 1.
Start/Stop
ends the test program.
Level 1
P2
Inlet valve 1 (compartment for Pre-
wash)
P3
Inlet valve 2 (compartment for main
wash)
P4
Inlet valve 3 (hot water)
P5
Inlet valve 4 (compartment for rinsing
agent)
P6
Door pull magnet
P7
Heater relay (separate or under control)
Level 2
P2
Drain pump
P3
Motor, normal operation
P4
Motor, delicate operation
P5
Long spin drying
INTERNAL COUNTER
The electronic control unit contains an internal
counter of the number of washing cycles.
To show the number of washing cycles in the
display:
1. Switch off the power switch, and connect
a jumper to E14.
2. Switch on the machine again.
3. Press the
P8
-button five times.
The counter is shown on the display.
The counter disappear when the jumper is
removed.
FAULT INDICATIONS
If a fault occurs during a program cycle, this is
indicated on the display after the program has
finished or been interrupted.
Water inlet fault
Check that the filter in the machine water inlet is
not blocked.
Overfilling
Too much water in the drum due to a fault in the
level sensing system or the inlet valve.
Draining fault
Draining has taken too long. Check the drain hose
and the drain pump as follows:
1. Has any object stuck in the drain hose
outlet? Clean out the hose.
2. Is the drain pump blocked by foreign objects?
Clean out the pump.
3. Is the drain hose kinked?
4. After solving the problem, run program 10
(Emptying).
Thermistor fault
The thermistor is faulty or short-circuited. The
washing program has finished without heating.
Temperature stop fault
Check the fuses and the heating element.
The washing program has finished without hea-
ting.
Motor fault
Wiring open-circuit or motor fault has been in-
dicated and the washing program has been inter-
rupted.
Pressure sensor fault
A drop in pressure has been detected in the first
rinse. This could be due to leakage in the level
sensor or in the hose leading to it. The washing
program has been interrupted.
Door lock
Indicated when the circuit control is broken.
Change the the circuit control.
TEST PROGRAM AND FAULT INDICATIONS
